Publicité
TECHNICAL DIVISION
1– REMOVE THE SCREWS FROM THE TUBE,
SO IT CAN BE DETACHED FROM THE HOOD
2– MARK THE CENTRE OF THE HOOD ON THE
WALL AND USE THE TEMPLATE SUPPLIED,
MAKING IT COINCIDE WITH THE CENTRE LINE
AND AT THE MARKED HEIGHT.
MARK AND DRILL HOLES IN THE WALL
ACCORDING TO THE TEMPLATE, FIT THE
WALL PLUGS SUPPLIED AS WELL AS THE 2
LOWER SCREWS, LEAVING THEM LOOSE (SEE
FOLLOWING ILLUSTRATION AND PAGE 3)
INSTALLATION MANUAL P-960
3– HANG THE HOOD FROM THE 2 LOWER
SCREWS AND SECURE IT TO THE WALL.
TIGHTENING THESE TWO SCREWS AND
FITTING THE TWO UPPER SCREWS
660066400125
Publicité
