Bebeconfort Titan Mode D'emploi page 47

•
Never modify the construction or the materials of the car seat and the seat belt without
consulting the manufacturer.
• Do not use the child restraint device without the cover. Do not replace the seat cover with a
cover other than that recommended by the manufacturer, because it will have a direct e ect
on the functioning of the child restraint.
•
This child restraint is e ective only if the instructions for use are respected.
•
Always fasten the child restraint even when the child is not sitting in it.
•
Never place heavy objects on the rear parcel shelf, to avoid the danger of projectiles in the
event of an accident.
•
Folding seats must always be locked in place.
•
If in any doubt about the correct installation or use of the system, the user is advised to
contact the distributor or the manufacturer of the child restraining device system.
CARE
Keep the car seat clean. Do not use lubricants or aggressive cleaning agents.
Inlay:
•
The inlay included in your Bébéconfort Titan seat plays an integral part in the e ciency of the
restraint system for your child from 9-15kg, group 1. It can be removed and the cover taken o
for washing, but it is essential to place it back again where it belongs and only use this o cial
Bébéconfort Titan inlay. This inlay is exclusively for use with the Bébéconfort Titan seat.
Fabric:
The cover can be removed for washing. If the cover needs to be replaced at any time, only use
•
o cial Bébéconfort cover because it constitutes an integral part of the restraint performance.
•
For safety reasons, shoulder pads are not removable. Clean it by using a damp cloth
•
Before cleaning check the label sewn into the various parts of the fabric, you will nd the
washing symbols indicating the method of washing each item.
EN
46