Fcc Statement - Skil LL932301 Guide D'utilisation

Always turn the laser tool off when not in use . Leaving the tool
on increases the risk of someone inadvertently staring into the laser
beam.
Do not attempt to modify the performance of this laser device in any
way. This may result in a dangerous exposure to laser radiation.
Do not attempt to repair or disassemble the tool. If unqualified
persons attempt to repair this product, serious injury may occur. Any
repair required on this laser product should be performed only by
qualified service personnel.
Use of other accessories that have been designed for use with other
laser tools could result in serious injury.
Do not operate the tool outdoors.
Do not place or store tool under extreme temperature conditions.

FCC STATEMENT

The manufacturer is not responsible for radio interference caused
by unauthorized modifications to this equipment. Such modifications
could void the user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received,
including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate
the equipment.
NOTE: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However,
4