tomado TLT4701W Mode D'emploi page 18

The control unit of the appliance is located on the inside. Check that the thermostat is off in position 0. Check that the voltage
corresponds with the voltage stated on the information plate and insert the plug in the socket.
Set the temperature with the thermostat and select a position between 1 and 7. We recommend setting the appliance
to position 3 or 4. The appliance will now cool continuously until the set temperature has been reached. Allow the appliance
to reach the required temperature with no food. Usually this will take 2 to 3 hours. After that, you can set the thermostat
to the required position and fill the appliance with food.
Position 0 - OFF, appliance is off
Position 1 - maximum temperature, the least cold
Position 4 - optimum temperature, colder
Position 7 - minimum temperature, the most cold
If the ambient temperature rises, set the appliance to a higher position in order to be able to guarantee the interior
temperature.
Set the thermostat 0 to switch off the appliance.
Attention:
The ambient temperature, the frequency of opening the door and the position of the appliance have an effect on
the temperature in the appliance. Take this into account when setting the thermostat.
• Do not place hot food in the appliance.
• You should never place hazardous, highly flammable or explosive substances such as alcohol, acetone or petrol in the appliance,
because there will be a hazard of explosion
• Carefully package meat and fish to prevent unpleasant smells.
• Leave sufficient space between the different foods, to allow the air to circulate properly.
• Do not place food against the rear wall of the appliance. The shelves have a stopper to prevent this.
• Do not leave the door open for longer than necessary.
• A high ambient temperature will have a negative effect on the energy consumption. Direct sunlight and other heat sources
near the appliance also have a negative effect.
• Keep ventilation holes free. Covered and dirty holes cause a higher energy consumption. Ensure sufficient space around
the larder, so that a proper ventilation and air flow around the appliance is possible.
• Do not open the door of the appliance more often than necessary and leave the door open as briefly as possible.
• The distance between the shelves and the rear wall ensures a free air circulation. Do not place food against the rear wall.
• Set the thermostat to a lower setting if circumstances allow.
• Allow cooked food that you want to store in the appliance to cool down to room temperature before placing it in the
appliance.
• Frost or ice will increase power consumption. Therefore, these should be removed regularly once they are 3 to 5 mm thick.
• A door rubber that does not close properly could increase the power consumption. Therefore, have it replaced by a skilled
person in time.
• If the instructions are not observed, this could lead to a higher power consumption.
Observe the following instructions to prevent food from getting contaminated
- When the door remains open for a longer period of time, the temperature in the compartments of the appliance could rise
significantly.
- Clean surfaces that could come in contact with food and regularly clean accessible discharge systems.
- Store raw meat and raw fish in suitable packaging in the refrigerator, so they cannot come in contact with other food or leak
liquid on other food.
- Freezer compartments with two stars are suitable for storing already frozen food, storing or making ice and making ice cubes.
- Compartments with one, two or three stars are not suitable for freezing fresh food.
USE
TIPS
EN - 18