Cleaning And Maintenance; Resolving Failures Yourself - tomado TLT4701W Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 31
The cooler section defrosts automatically. Regularly clean the larder to guarantee a proper function.
Before cleaning the appliance, switch it off by setting the thermostat to OFF and removing the plug from the wall socket.
Remove all food from the larder. Clean the inside of the larder. Use warm soapy water with a neutral cleaning agent
to prevent nasty smells. Wipe the inside of the larder after cleaning with clean water and properly wipe everything dry.
Leave the appliance to dry for 1 to 2 hours. The shelves, drawers and door compartments can be removed from the larder
easily and washed by hand. These components may not be cleaned in the dishwasher.
For areas in the larder that are difficult to clean, such as small openings or corners, it is recommended wiping them clean
regularly with a soft cloth or brush. If necessary, a tool can be used, such as thin sticks (cocktail sticks, for example), to make
sure no contamination can occur in these areas.
Clean the outside of the larder and the door rubbers with a soft damp cloth.
Clean the rear of the larder at least one per year with a vacuum cleaner, so that the condenser and ventilation holes remain
clean and the larder is able to function as optimal as possible.
Do not use hard brushes, steel wool, abrasives (such as toothpaste), organic solvents (such as alcohol, acetone, oil, etc.),
boiling water, acid or alkaline product to clean the larder, as this could damage the surface and interior of the larder.
Boiling water and benzene could deform or damage plastic components.
REPLACING THE LED LAMP
This appliance has been provided with a LED lamp. This lamp lasts for a longer period of time. When the LED lamp
in the appliance is broken, you are not able to replace it yourself. Contact the Inventum service department.
Breakdown
Appliance does not do anything;
led does not light up
Temperature in the larder is too high
or too low
Appliance makes noise
Note: bubbling and expansion noises in the cooling circuit are normal.
This symbol means that this product should not be disposed of with regular household waste (2012/19/EU).
Observe the rules that apply in your country for the separated collection of electric and electronic products.
Correct disposal of the product prevents negative consequences for the environment and for public health.
The packaging material of this product can be recycled 100%, return packaging material separately.

CLEANING AND MAINTENANCE

RESOLVING FAILURES YOURSELF

Cause
Plug not in socket
Incorrect thermostat setting
Ventilation openings are blocked
Is the appliance properly installed?
Does the rear of the larder make
contact with something?
RECYCLING
EN - 20
Solution
Insert the plug in the socket.
Set the thermostat to the correct setting
Clean the ventilation openings
Check the installation
Check this and move the larder forward

Publicité

Table des Matières
loading

Table des Matières