Maintenance And Service; Maintenance And Cleaning - Bosch PEX 270 A Mode D'emploi

OBJ_BUCH-499-001.book Page 22 Monday, December 3, 2007 12:34 PM
22 | English
Polishing (PEX 270 AE)
For the polishing of weathered paint or buffing
out scratches (e.g., acrylic glass), the machine
can be equipped with appropriate polishing ac-
cessories such as lamb's wool bonnet, polishing
felt or sponge (accessories).
Select a low stroke rate (setting 1 – 2) for polish-
ing in order to avoid excessive heating of the
surface.
Apply polishing agent crosswise or in a circular
motion with a polishing sponge and moderate
pressure, and then allow it to dry lightly.
Polish the partially dried polishing agent with
crosswise or circular motions using a lamb's
wool polishing bonnet.
Clean the polishing accessories regularly to en-
sure good polishing results. Wash out polishing
accessories with a mild detergent and warm wa-
ter; do not use paint thinner.
Application Table
The data in the following table are recommend-
ed values.
The most favourable combination for working is
best determined by practical testing.
Roughening varnish
Touching up varnish
Removing varnish
Softwood
Hardwood
Veneer
Aluminium
Steel
Derusting steel
Stainless steel
Masonry, stone
1 609 929 M13 | (3.12.07)

Maintenance and Service

Maintenance and Cleaning

Before any work on the machine itself, pull
the mains plug.
For safe and proper working, always keep
the machine and ventilation slots clean.
WARNING! Important instructions for con-
necting a new 3-pin plug to the 2-wire cable.
The wires in the cable are coloured according to
the following code:
Do not connect the blue or brown wire to the
earth terminal of the plug.
Important: If for any reason the moulded plug is
removed from the cable of this power tool, it
must be disposed of safely.
If the machine should fail despite the care taken
in manufacturing and testing procedures, repair
should be carried out by an after-sales service
centre for Bosch power tools.
In all correspondence and spare parts order,
please always include the 10-digit article
number given on the type plate of the machine.
After-sales service and customer
180/320 2/3
assistance
120/400 4/5
Our after-sales service responds to your ques-
40/80 5
tions concerning maintenance and repair of your
40/240 5/6
product as well as spare parts. Exploded views
60/320 5/6
and information on spare parts can also be
found under:
240/320 5
www.bosch-pt.com
80/240 4/5
Our customer consultants answer your ques-
60/240 5
tions concerning best buy, application and ad-
40/120 6 justment of products and accessories.
120/240 5
80/200 5/6
Bosch Power Tools