Memory Handling - Microlife PF 100 Mode D'emploi

8.

Memory Handling

The 240 measuring data can be reviewed on the display:
1. Switch the monitor on and press the memory
scroll buttons.
2. By pressing the «<» button, you can see the
latest value stored in the memory with date and
time; pressing this button once at a time shows
all stored data. If you keep pressing the button
you can move quickly through the memory.
3. The «>» button works in the opposite direction.
• Memory Capacity Low
When the memory covers 230 or more
data, «MR XX» is blinks after the monitor is
switched on to indicate that the remaining
memory capacity is low.
• Memory Full
When the memory is full with 240 data,
the monitor gives a warning «beep»
when switching on and «MR 240»
is blinks. From now on, data is still
memorised but the oldest values are
automatically erased!
• Memory Clear
Please note: the memory is automatically
cleared after data transfer to computer.
Clearing all data from the memory manually should be done when you intend
to give the monitor to another person. To clear all data press the «<» and the
«>» buttons simultaneously for 5 seconds, and then release the buttons. «clr»
starts blinking in the display for about 3 seconds. If you really want to erase all
data from memory you need to press the ON/OFF button during these seconds.
Otherwise the monitor moves back to normal operation and the data remains.
• Clear the last measurement
You can erase the last memory reading by pressing both memory scroll
buttons simultaneously for 5 seconds. After releasing the buttons «clr» will
flash on the screen for 3 seconds. To erase the last reading you need to press
both buttons again while the screen is flashing.
11