Cleaning And Disinfecting; Cleaning / Disinfecting The Mouthpiece; Cleaning / Disinfecting The Measuring Tube - Microlife PF 100 Mode D'emploi

Moniteur d'asthme électronique
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Significance of the Traffic Light Scheme
Green area - OK
The lung disease is well under control. A higher medication dosage is not required.
Yellow area - Caution
Should your measured values frequently be located in this area, increase your
medication dosage as discussed with your physician.
Red area - Danger
It is dangerous if your measured values are in this area! Act as discussed with your
physician or seek emergency medical treatment.
7.

Cleaning and Disinfecting

7.1. Cleaning / Disinfecting the Mouthpiece

We recommend disinfecting the mouthpiece
before your first use and at least once a week
using the following procedure:
1.
Disconnect the mouthpiece from the
measuring tube and put it for at least
10 minutes into continuously boiling water.
2.
Afterwards, put the mouthpiece on a fresh
paper towel and let it air dry.
3.
Reassemble the mouthpiece on the
measuring tube.
Alternatively, you can disinfect the mouthpiece by putting it into commonly
available disinfecting solutions. Please carefully follow the instructions for the
disinfecting solution! Make sure that it is suitable for a mouthpiece.

7.2. Cleaning / Disinfecting the Measuring Tube

The performance of the monitor can be affected
by spitting or coughing into the measuring tube.
In this case please rinse the tube with distilled
water (available at a pharmacy or drugstore).
Please do not use tapwater.
9

Publicité

Table des Matières
loading

Table des Matières