Carrying Out A Measurement - Microlife PF 100 Mode D'emploi

Please note:
•
If you hold down the arrow key for more than 2 seconds it speeds up.
•
Date /time can also be set easily from computer when you run the Microlife
Asthma Analyser Software.
4.

Carrying out a Measurement

•
When different people use this meter their individual readings cannot be
assigned to different users when the data is stored.
•
If time/date is not set, measurements can not be performed.
•
If another person intends to use the device permanently, all data from the
previous user should be erased as explained in this manual.
•
In case another user has already used the monitor, we recommend
disinfecting the measuring tube as explained in this manual. In this case we
also recommend that each user uses a new mouthpiece. Extra mouthpieces
can be ordered through your Microlife dealer.
1. Press the ON/OFF button to turn the monitor
on. At first, the last result of the memory is
shown («0» if there are not yet data) and then
the device indicates «READY» for a measure-
ment by two short beeps and blinking arrows.
2. You can perform the measurement while
standing or sitting upright. For better compa-
rison of your data you should always perform
the measurement in a similar position.
3. Hold the monitor with both hands on the two
rubber areas (compartments).
4. Inhale completely and hold your breath for a
moment.
5. Cover the mouthpiece tightly with your lips.
6. Blow into the measuring tube as hard and as
fast as you can.
PF 100 6