Preparation And Usage Of The Device; Cleaning - Microlife NEB50 Mode D'emploi

2. Preparation and usage of the device

Prior to using the device for the first time, we recommend cleaning it as per
the instructions in this manual.
Please refer to the foldout page with the figures on the correct usage of the
device at the beginning of the manual.
1. Please assemble the nebuliser as shown in the figures. Ensure that all
parts are complete.
2. Fill the nebuliser with the inhalation solution as per your doctor's
instructions. Please ensure that you do not exceed the maximum level.
3. Please connect the nebuliser to the device using the air hose and then
plug the device into the electricity supply (230V~ / 50Hz).
4. Now switch on the device (I) and place the mouthpiece in the mouth or fit
the mask.
If possible use the mouthpiece as this gives a better drug delivery to the
lungs. However, you may prefer to use the facemask and you will find two
sizes are supplied to suit different size faces. The mask should completely
enclose the mouth and nose areas.
5. During the therapy, breathe in and out calmly. Sit in a relaxed position with
the upper part of the body upright. Stop inhalation if you feel unwell.
6. After completion of the inhalation period recommended by your doctor,
please switch off the device (0) and unplug it from the electricity supply.
7. Empty the remaining medication from the nebuliser and clean the device
as per the instructions in this manual.

3. Cleaning

The nebuliser, face mask and mouthpiece may only be used by one
person. After application, all parts must be taken apart and rinsed under
flowing water. Then place all parts on a clean paper towel and leave to dry.
3