the plug which is marked with the letter
E or by the earth symbol
green or green and yellow .
2 . The wire which is coloured blue must be
connected to the terminal which is marked
with the letter N or coloured black .
3 . The wire which is coloured brown must be
connected to the terminal which is marked
with the letter L or coloured red .
Warning – This appliance must be earthed.
If the unit is to be put out of operation
definitively, take it to a local recycling
plant for a disposal which will not be
harmful to the environment .
3 Applications
By vaporizing a fog fluid, this fog machine will
create artificial fog which can be used to en-
hance any light effects (e . g . in clubs, on stage,
in party rooms) .
The cable remote control provided allows
to operate the fog machine in three modes
( manual mode, continuous mode and timer
mode) . As an alternative to the remote control,
the unit can also be operated via a DMX con-
troller with DMX 512 protocol . Thus, it is easily
integrated into a professional lighting system .
4 Filling Up Fog Fluid
WARNUNG 1 . While filling up fog fluid, the
2 . Never add flammable fluids of any kind to
the fog fluid! Explosion hazard!
3 . The unit is not splashproof . If fluid gets inside
the unit, it must be cleaned and checked by
skilled personnel before it is operated .
1) Unscrew the tank cap (2) .
2) Fill up the tank with fog fluid (
4 .1) . If any fluid is spilt, wipe it off immedi-
ately with a cloth so that it will not get inside
the unit .
3) Tightly close the tank .
12
, or coloured
unit must not be connected
to the mains . Always discon-
nect the mains plug from
the socket before filling up!
☞
4.1 Suitable fog fluid
The following fog fluids from IMG STAGELINE
suitable for the unit are available in 5 litre con-
tainers:
Item
NF-502L
NF-502SL extra long fog effect
Only use the fluids listed above, otherwise no
liability will be accepted for correct operation .
The following scents from IMG STAGELINE may
be added to the fog fluid:
Item
NF-32
NF-62
NF-72
A bottle of scent (contents 25 ml) will be suffi-
cient for 5 litres of fog fluid; higher quantities
may clog the fog machine .
5 Setting Up / Installing the Unit
•
The heat produced inside the unit must be
dissipated by air circulation . Make sure that a
minimum space of 20 cm is provided around
and above the unit and that the air vents of
the housing are not covered .
•
During operation the fog output nozzle will
become very hot . Always ensure a minimum
distance of 50 cm to easily flammable mate-
rial or material sensitive to heat .
•
Adjust the unit so that the hot fog stream
will not directly hit persons – risk of burns!
Remove the complete packaging material . Make
sure that there are no packaging remnants at
the fog output nozzle .
Place the unit on a horizontal surface or
mount it via its bracket (1) [e . g . on a cross
arm via a mounting clip] . For precise horizon-
tal adjustment of the unit, slightly release the
two screws (4) on both sides of the mounting
bracket, readjust the position of the unit, then
chapter
retighten the two screws .
•
When installing the unit at a place where peo-
ple may walk or sit under it, additionally se-
cure it [e . g . via a safety rope on the mounting
Feature
long fog effect
Scent
Vanilla
Mixed fruit
Strawberry
Order No.
38 .1820
38 .1830
Order No.
38 .1780
38 .1800
38 .1810