SX 344
5. In the same way, you must connect the vacuum hose to the machine and to the accessory
handle.
6. Put the plug of the cable in the socket (see safety regulations).
7. Switch on the water pump and vacuum motor through the corresponding switches.
At this point the machine is ready to operate.
Attention: Do not use the machine as a vacuum cleaner!
Do not let the pump run dry!
Working method
For a routine maintenance cleaning of the carpet or floor, it is suitable to proceed by spraying and
washing simultaneously. Push the lever on the wand handle to spray the solution.
You can apply pure detergent on persistent spots, by using aerosol bombs which you can find on the
market with solvents suitable to any kind of spot. Use quality and suitable detergents only, in order to
avoid damages to the surfaces. Always test the chemical on a small spot where a possible damage
cannot be seen.
Concerning the washing method, considering a rectangular surface, we suggest you should do as
follows: after removing as much furniture as you can, divide ideally the surface in several stripes and
12