Columbus SX 344 Mode D'emploi page 12

Machine à injection-extraction
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

x
Verify that the cable plug is complying with the outlet.
x
Do not modify plug.
x
Do not use adapters or multiple sockets, without knowing the electrical input of each user.
x
If any electrical extension is used, check that it corresponds to the absorbed power of the machine
and that the connection of the plug with the socket is complying and sealed.
x
Take care of the electrical cable. It must be integral and protected from water, tears and chemical
agents. Do not repair the cable in case of tears, but replace it with a new one. The cable must be
replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a
hazard.
x
Do not pull the cable to drag the machine or to pull the plug out.
x
Pull the plug out only when the machine is switched off.
x
Do not handle the plug with wet hands.
x
Unplug cable before servicing machine.
FOR SAFETY:
x
Do not let the machine being used by children and people unable to understand the danger
connected with the use of electrical power.
x
Do not bring the end of the suction hose or one of the accessories near your face or others',
particularly near ears and eyes: the sucked air could seriously damage them.
x
If the machine is used as a wet vacuum cleaner, you must check the level of water in the
recovery tank, in order to prevent water from being sucked by the vacuum motor.
x
If the chemical you are using produces foam, or if you are cleaning carpet previously
treated with shampoo, you must put some antifoaming liquid into the recovery tank. In the
long run, the foam sucked by the motor can damage it.
x
In case of abnormal working (very noisy motor, not running pump, extreme temperature rise, or
other suspicious signals) switch off the machine and pull the plug out.
x
If foam or liquid escapes from the machine, switch machine off immediately.
x
After using, store the machine, well cleaned, in a cool and dry place.
The manufacturer cannot be held responsible for any damage/injury caused to persons or property,
because of the incorrect use of the machine due to procedures being used which are not specified in
this instruction manual.
Attention: all the electrical repairs must be performed by qualified personal only!
PROTECT THE ENVIRONMENT
Please dispose of packaging materials and old machine components in a safe
environmentally way according to your local waster disposal regulations.
Always remember to recycle.
10
SX 344

Publicité

Table des Matières
loading

Table des Matières