Before Starting; To Start The Product; To Stop The Product - Husqvarna K 4000 Manuel D'utilisation

4. Push the TEST button (blue).
5. The ground fault circuit interrupter should trip and
the machine switch off instantly. If not, contact your
dealer.
6. Push the RESET button (green).

Before starting

WARNING: Please read the operator's
manual carefully and make sure you
understand the instructions before using the
product.
WARNING: Wear personal protective
equipment. See
equipment on page 7 .
WARNING: Make sure no unapproved
persons are in the working area, otherwise
there is a risk of serious personal injury.
WARNING: Make sure the mains voltage
agrees with the value on the rating plate on
the product.
Perform daily maintenance. See section
on page 20 .
To connect water
1. Connect the water hose to the water supply (A).
2. Turn the water tap (B) to let the water go or stop.
To switch on the ground fault circuit interrupter
WARNING: Never use the tool if the ground
fault circuit interrupter is not delivered with
397 - 001 -
Personal protective
MAINTENANCE
the tool. Carelessness can cause serious
personal injury or even death.
1. Make sure the ground fault circuit interrupter is
closed.
2. Start the product. If the LED is not illuminated, push
the RESET button (green).
3. Examine the ground fault circuit interrupter.

To start the product

1. Hold the front handle with the left hand.
2. Hold the rear handle with the right hand.
3. Push the power switch lock in with your right-hand
thumb and push the power switch.
4. Operate the product without load in a safe manner
for at least 30 seconds.

To stop the product

WARNING: The cutting blade continues to
rotate up to a minute after the motor stops
(known as blade coasting.) Make sure that
the cutting blade can rotate freely until it
completely stops. Carelessness can cause
serious personal injury.
19