Quick Start - Kinetec Spectra; Quick Start - Kinetec Spectra Dc - Kinetec Spectra Manuel D'utilisation

Quick Start - Kinetec Spectra

Set up the patient and proceed as below:
Beginning
Switch the unit ON
Starting the session with the parameters from
the previous session.
Note: the values in the display column are given as an example. In actual use, they will come
from stored programs or previous sessions.

Quick Start - Kinetec Spectra DC

The Kinetec Spectra DC continuously records the session data (with no memory limits).
However, if you do not want to analyse the current session later on, or for the session of a new
patient where you do not wish to create a report, we recommend that you use the 1st patient in
the list. This will not affect other patients' sessions.
Set up the patient and proceed as below:
Beginning
Switch the unit ON
Selecting the patient
Selecting the patient index
Entering the index
Changing the name, if needed
Confirming the patient
Starting the session with the parameters from
the previous session, unless you are using an
optimised program (see the instruction
manual for the Kinetec Data Capture
software). The session will be recorded for the
selected patient.
Note: the patient selection will remain the same unless the machine is switched off and then on
again (back to the 1st patient on the list) or until it is changed. See the instruction manual for the
Kinetec Data Capture software for more information.
WARNING: Always check the motion parameters displayed on the remote control before starting
the session.
Spectra & Spectra DC
Keys to press
Spectra Vxx.x
Movement Verif.
Please Wait
30 STOP
Warm up
30 STOP
30 RUN
Keys to press
Spectra Vxx.x
Movement Verif.
Please Wait
Nom
Prenom
30 STOP
Warm up
30 STOP
PROGRAM
Patient List
Or
Nom
Prenom
Nom
Prenom
Or
30 STOP
30 RUN
EN
Display
KINETEC
KINETEC
35 70
Or, according to the mode selected
during the previous session.
35 70
KINETEC
The value change at the speed of
45 70 the movement.
Display
KINETEC
xx When the machine is switched on,
the patient selected is always the first
xx
on the list.
KINETEC
Or, according to the mode selected
during the previous session.
35 70
Check if the hand control is not
35 70
blocked (See page 5).
Nr8
Displaying stored programs.
EMPTY
The index is after program Nr16 or
before Nr1.
xx
Displaying the patient
xx
Displaying a patient's name or a
04
number if it has not been added to
04
the Kinetec Data Capture software.
KINETEC
Exiting index mode.
35 70
KINETEC
The value change at the speed of
45 70 the movement.
Remarks
Remarks
6/16