How To Modify Programs Program Mode - Kinetec Spectra Manuel D'utilisation

How to modify programs PROGRAM MODE?

The KINETEC Spectra allows you to store up to 16 programs, including the type of treatment, ROM, speed,
load, pauses and timer.
The original parameter values of the program are empty.
These values can be modified and saved at any time by following the procedure below or by using the
Kinetec Data Capture software (only with the Kinetec Spectra DC).
Beginning
To switch off the unit
Press the two keys at the same time and
switch the unit ON
Then
To change the program if necessary
To choose the treatment mode
Or
To display the extension or flexion limit of the
movement
To change the limit of movement if necessary
To validate the new value, press another key
or wait more than 3 seconds
To record the program 10
Then
OR
To cancel the program
To exit program mode, switch OFF and switch
ON the unit.
Spectra & Spectra DC
Keys to press
SPECTRA VXX.X
PROGRAM
PROGRAM
25 KINETEC 110
Or
PROGRAM
30 WARM UP 90
PROGRAM
30
PROGRAM Nr10
30
Or
PROGRAM Nr10
30
PROGRAM Nr10
30 KINETEC
Or
PROGRAM Nr10
SPEED: 2
PROGRAM Nr10
LOAD : _ _ _ _ _
PROGRAM Nr10
TIMER
PROGRAM Nr10
PAUSE EXT
PROGRAM Nr10
SAVE:+ CLEAR:-
PROGRAM Nr10
PROGRAM Nr11
PROGRAM Nr10
CLEARING
PROGRAM Nr11
SPECTRA VXX.X
EN
Display
Check if the hand control is not
blocked (See page 5).
KINETEC
Welcome text during 3 seconds
Nr2
The program number blinks.
EMPTY
Nr10
The new program number blinks.
The display indicates the selected
Nr10
treatment mode, the program
number blinks again.
Nr10
KINETEC 90
KINETEC 90
The value blinks.
KINETEC 90
The new value blinks.
120
While the value blinks press
the
to change if necessary.
00H00MIN
0S
The program 10 has been recorded
SAVING
and the display indicates the next
program so you can change another
program.
EMPTY
The program 10 has been cancelled
and the display indicates the next
program so you can change another
program.
EMPTY
KINETEC
To use the modified program see
page 10.
Remarks
or key
9/16