Start/Stop/Reverse Function; Locking The Hand Control Setting; Possible Values For Each Parameter; Default Setting - Kinetec Spectra Manuel D'utilisation

START/STOP/REVERSE function

As with all KINETEC systems, the KINETEC Spectra and Spectra DC devices are equipped with
ON/OFF/INVERT functions.
Press the key of the hand control. The movement stops,
Press the key of the hand control. The movement starts in the opposite direction.
For optimum safety, always give the hand control to the patient before starting the system.
Procedure to stop the machine:
To stop the machine's movement: Press the
To switch power off: press the ON / OFF switch (9)(see page 4)

Locking the hand control setting

The hand control allows the patient to control the machine as appropriate.
Simultaneously press the
The display reads LOCK, you cannot change the parameters, if you try the display reads LOCK SOFT.
To unlock the hand control, simultaneously press the same keys, The display reads UNLOCK.
We recommend that you lock the hand control when you give it to the patient.
Note: The hand control locking is preserved when you switch the unit ON/OFF.

Possible values for each parameter

• Treatement Mode
• Extension limit
• Flexion limit
• Speed
• Force
• Extension pause
• Flexion pause
• Timer
• Number of Programs
• Number of Patients *
* Spectra DC only

Session Time

This function shows the running time (in minutes) of the session (motor functioning).
It directly accessible by the key
This counter is reset each time the unit is switched ON.
Spectra & Spectra DC
Caution:
key
and keys to lock the hand control,
Possible values
-10 to 115°
-5° to 120°
1 to 5 (from 45° to 155° per
minute)
1 to 6
0 to 900 seconds (15minutes)
0 to 900 seconds (15minutes)
No timer(00H00) to 24H00
16
16
, the display shows TIME
EN

Default setting

Normal
30°
70°
2
6
0
0
0
Empty
Empty
02H35
5/16