Testing The Ds2416; Installing The Test Program; Using The Test Program - Yamaha DS2416 Mode D'emploi

Testing the DS2416

A test program is included with the DS2416 to make sure that the card, driver,
and DSPs are functioning correctly.

Installing the Test Program

Insert the supplied floppy disk into the floppy disk drive.
1
Double-click Setup.exe and follow the on-screen prompts.
2
The Test program and its associated files are installed.

Using the Test Program

From the Start menu, select Programs, DSP Factory, ds2416ck.exe.
1
When the Test program window appears, click the CHECK START
2
button to run the tests.
The Test program checks:
1. How many DS2416 cards are installed.
2. Whether the DS2416 drivers are installed
3. Whether the DSP chips are functioning correctly.
The test results appear as each test is completed. If all tests are successful, a
sine wave test tone can be produced through the OUT L, OUT R, D OUT, and
outputs 1 through 4 of any connected AX44s by clicking the test tone button.
If a test fails, follow the advice provided.
If the driver test fails again after restarting, try reinstalling the driver.
If the DSP test produces a "DSP ERROR" or "DSP NG" message, the DS2416
has a hardware problem and you should contact your Yamaha dealer.
Click the EXIT button to quit the Test program.
3
Testing the DS2416
DS2416—Owner's Manual
9