General Operation - AEG NDR 4378 DAB+ Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 19
Rear View (without illustration)
DC 14 V
connector
DAB / FM Wire antenna
Remote Control
1 INFO button (Show informations)
2 FUNC button (Function mode)
3
button (Playblack / Pause)
4
button (Stop)
5 SCAN button (Start scanning for radio stations)
6 ENTER button (Confirm)
7 VOLUME + / – buttons (Volume)
8 PLAY MODE / PRE / MEM button (Playback Mode /
Stored radio stations selection / Storing)
9 + 10 / – 10 buttons
10 TUNING /
button (radio station search downward/
previous track)
TUNING /
button (radio station search upward/
next track)
11 MUTE button (Mute)
Installation
• Choose a suitable location for the device. Suitable loca-
tions are dry, even and antislip surfaces on which you may
operate the device easily.
• Make sure there is proper ventilation for the device!
• Sensitive surfaces such as the display may be protected
by plastic foil. Remove this foil.
Power Supply (Adaptor)
1. Make sure the grid voltage corresponds to the figures on
the rating plate.
2. Insert the grid plug into a properly installed three prong
socket. Connect the device with the plug connector by
inserting its plug into the DC 14 V jack of the device.
CAUTION:
• Only use the supplied power adaptor for this device.
Do not use for other devices.
• Only use power adaptor with 14 V (
adaptors may cause damage to the device.
NOTE:
Disconnect from mains power supply during longer periods
of non-use.
Remote Control
NOTE:
The lithium cell in the battery compartment of the remote
control was secured with foil for transport. This extends the
battery life. Remove this foil before initial use to operate
the remote control.
For wireless operation from a distance of up to 5 meters.
During operation, please ensure a clear line of view between
NDR4378DAB+_IM
the remote control and the sensor (10) on the device. If
this range should diminish, the battery must be replaced.
Replace the battery as follows:
1. Open the battery compartment.
2. Replace the cell with a battery of the same type (CR 2032).
Please observe the correct polarity.
3. Close the battery compartment.
WARNING:
• Do not expose the batteries to intense heat such as
sunlight, fire or similar. There is a risk of explosion!
• Keep batteries away from children! They are not a toy.
• Do not open batteries with force.
• Avoid contact with metallic objects (rings, nails, screws,
etc.). There is a risk of short circuit!
• Batteries may heat up considerably through a short
circuit or may even ignite. It could result in burns.
• The battery terminals should be covered with adhesive
tape during transport for your safety.
• Batteries can leak out and can lose battery acid. If the
device is not used for a longer period of time, remove
the battery from the remote control.
• If a battery does leak out, do not rub the liquid into your
eyes or the mucous membranes. In case of contact,
wash your hands, rinse your eyes with clear water, and if
the symptoms persist, consult a doctor.
CAUTION:
• Batteries can leak out and can lose battery acid. If the
device is not used for a longer period of time, remove
the battery from the remote control.
• Batteries do not belong in the household waste. Please
dispose of spent batteries at authorized collection
points or at the dealer.

General Operation

NOTE:
• You will find some buttons both on the device and
the remote control. Identical buttons have the same
), other
function.
• The operation of the device is described by the buttons
on the device.
Switch the Device on/off
• Press the I / button to turn the device on.
• To turn off the device, press the I / button again. The
control lamp
NOTE:
After approx. 15 minutes without signal or with very poor
signal, the device will automatically switch to standby.
FUNCTION button
For switching between DAB, FM, USB, BT and AUX mode.
English
(3) lights up red.
06.04.16
41

Publicité

Table des Matières
loading

Table des Matières