Master/Slave Mode - Velleman VDPL5X5RGB Mode D'emploi

CS--
SLNd
SHNd
SOUN
SENS
diSP
tC25
Hour
7.2 Choosing the Mode
You can use the device on its own as a stand-alone unit or connect it to other similar fixtures.
Stand-Alone Mode
In stand-alone mode, the device runs on one of the built-in programmes or with sound activation.
To set the device to stand-alone mode:
1. Unplug any connection from the DMX input [6 or 7] of the device.
2. Press MENU and choose one of the playing modes – built-in programmes or sound activation – with UP or
DOWN.
3. Press ENTER to confirm.
4. Choose the mode value with UP or DOWN and press ENTER to confirm.

Master/Slave Mode

The master/slave mode allows connecting several devices to a single master device. All slave devices will then
work synchronously with the master device.
Set one device to master mode and all other devices to slave mode.
1. Unplug any connection from the DMX input [6 or 7] of the master device (the first device in the chain).
2. Connect the DMX input of the first slave device to the DMX output [6 or 7] of the master device.
3. Connect the DMX input of the subsequent slave devices to the DMX output of the previous slave device.
4. Set up the master unit as described in Stand-Alone Mode.
5. On each slave device, press MENU until <SLNd> appears. Press ENTER to confirm.
DMX channel values
1-channel mode
channel
1
V. 01 – 21/08/2014
programme speed
slave mode
stand-alone mode
sound mode
sound sensibility
display inversion
temperature
device working time
from-to description
000-007 blackout
008-022 show 1
023-037 show 2
038-052 show 3
053-067 show 4
068-082 show 5
083-097 show 6
098-112 show 7
113-127 show 8
128-142 show 9
143-157 show 10
158-172 show 11
173-187 show 12
188-202 show 13
203-217 show 14
218-232 show 15
233-247 show 16
248-255 show 1 to 16 with sound control
VDPL5X5RGB
CS00
master
slave 1 to slave 4
tLSH (basic chase + sound control)
FLSH (4 corners + sound control)
sound on-off
00-15 (0-100 %)
display/reverse display
tC00-tC99
0-9999
6 ©Velleman nv