Fleetsync: Alphanumeric 2-Way Paging Function; Selcall (Selective Calling) - Kenwood Nexedge Serie Mode D'emploi

FleetSync: ALPHANUMERIC 2-WAY PAGING FUNCTION

FleetSync is an Alphanumeric 2-way Paging Function, and is a protocol owned by
JVC KENWOOD Corporation. FleetSync enables a variety of paging functions
on your transceiver, some of which depend on dealer programming.
Your dealer can set up either FleetSync or FleetSync II on your transceiver.
Transceivers set up with FleetSync can communicate with other transceivers that
have been set up with FleetSync. Likewise, transceivers set up with FleetSync II
can communicate with other transceivers set up with FleetSync II. However,
transceivers set up with FleetSync cannot communicate with transceivers that
have been set up with FleetSync II, and vice-versa.
Note: This function is available only in analog operation.

SELCALL (SELECTIVE CALLING)

A Selcall is a voice call to a particular station or to a group of stations.
■ Transmitting
1 Select your desired zone and channel.
2 Press the key programmed as Selcall or Selcall + Status to enter Selcall
mode.
3 Press the
• If Manual Dialing is enabled, you can enter the station ID by using the
microphone keypad, or by using
cycle through the digits to select a digit, then press the
the digit and move the cursor to the right. Repeat this process until the
entire ID is entered.
4 Press the microphone PTT switch and begin your conversation.
■ Receiving
An alert tone will sound and the transceiver will automatically enter Selcall
Mode.
The calling station's ID will appear when a Selcall is received. When the call
station's ID appears on the display, you can respond to the call by pressing the
microphone PTT switch and speaking into the microphone.
/ keys to select the ID of the station you want to call.
the / keys. When using the / keys,
key to set
17