What To Do If; Correcting Malfunctions - AEG SK 98800 Notice D'utilisation

What to do if ...

Correcting Malfunctions

A malfunction may be caused by only a minor fault that you can recti-
fy yourself using the following instructions. Do not perform any other
work on the appliance if the following information does not provide
assistance in your specific case.
Important! Repairs to refrigerators/freezers may only be performed by
competent service engineers. Improper repairs can give rise to signifi-
cant hazards for the user. If your appliance needs repairing, please
contact your specialist dealer or your local Customer Care Department.
Appliance does not work.
Appliance cools too much.
The temperature display
shows "¨".
The food is too warm.
42
Symptom Possible Cause
Appliance is not switched
on.
Mains plug is not plugged
in or is loose.
Fuse has blown or is
defective
Socket is defective.
Temperature is set too
cold.
The electronics in the
appliance have detected a
fault that prevents the
ACTUAL temperature being
measured.
Temperature is not proper-
ly adjusted.
Door was open for an
extended period.
A large quantity of warm
food was placed in the
appliance within the last
24 hours.
The appliance is near a
heat source.
Remedy
Switch on the appliance.
Insert mains plug.
Check fuse, replace if
necessary.
Mains malfunctions are to
be corrected by an electri-
cian.
Press „+" (WARMER)
button.
The appliance will continue
to function using a backup
programme until your local
Customer Service engineer
has repaired the appliance.
Please look in the "Starting
up and Temperature regu-
lation" section.
Open the door only as long
as necessary.
Turn the temperature
regulator to a colder set-
ting temporarily.
Please look in the
"Installation location" section.