Connecting And Starting; Led Light - Tetra AquaArt Explorer Line 30 Mode D'emploi

English translation of the original German
instructions
 Pull out the plugs of all the electrical devices
installed in the aquarium.
 Remove the aquarium lid.
 Select a position to install the filter box on the
inside of the tank which is not curved.
 Ensure that you keep the filter the required
distances from the base and from equipment
in the aquarium.
The required distances are set out in the
attached instructions for the filter box.
 Ensure that you satisfy the minimum
immersion depth (as specified on the outside
of the filter box).
 Secure the filter box vertically on the inside of
the tank as shown in the instructions for the
filter box.
 Install the heating element in the filter box as
described in the instructions for the filter box.
Upon delivery, the cable guides and optional
positions for electrical devices in the aquarium
lid are closed with covers. The covers can be
removed by hand or with a pair of pliers.
ATTENTION!
The aquarium lid may be damaged if too
much force is used to remove a cover.
 Score the edges of the cover with a
sharp knife before you remove the
cover.
 Remove the cover carefully.
 If the filter box is installed level with the
aquarium lid, carefully remove the cover from
the corresponding optional position in the
aquarium lid (Figures B and C).
 If the filter box is installed below the aquarium
lid, carefully remove the covers from the cable
guides for the mains cables of the filter and
heating element (Figures B and C).
8
 If the cable guides or option positions have
sharp edges, smooth them with a small file.
 Route the mains cables for the filter and
heating element upwards out of the aquarium.
 Follow the attached instructions for the filter
box, filter and heating element to complete the
remainder of the installation work.
Installing additional electrical
devices
You can install additional electrical devices (for
example heating elements) in the aquarium if
required.
 Pull out the plugs of all the electrical devices
installed in the aquarium.
 Install electrical devices as described in the
relevant instructions for use and other
instructions supplied by the manufacturer.
 Carefully remove the covers from the required
cable guides and optional positions in the
aquarium lid (Figures B and C).
 Proceed as described in the previous section.

Connecting and starting

 Start the electrical devices installed in the
aquarium as described in the attached
instructions.

LED light

 Fit the plug into the socket.
There are two switch positions for selecting the
colour of the lighting:
• Day lighting: The lighting unit emits daylight
white light.
• Night lighting: The lighting unit emits blue
light. This creates an attractive moonlight
effect.
• Ideally the light should be on for 8 to 12 hours
per day.