Quick Start Guide - Core Products Pain Remedy Manuel D'instruction

Quick Start Guide for Simple Use
1. Before using the Pain Remedy TENS charge the
CONTROL unit.
2. Snap the ELECTRODE pad into the round CONTROL unit.
NOTE: both snaps must be attached for this TENS system to work.
3. Remove the electrode pad film and securely place the
adhesive pads directly on the skin over the pain area.
4. Turn the CONTROL Unit on by pressing the power button.
NOTE: if the indicator light is red, the unit needs to be charged.
5. Adjust the intensity of the CONTROL Unit by pushing the +
or - button. Do this until the sensation is comfortable - up
to 20 levels.
NOTE: Intensity level will need to be adjusted each time the unit
is powered on.
6. Treatment time is 3 hours. For every 30 minutes
of treatment, the unit goes through a cycle of
4 pre-programmed modes.
NOTE: Unit will automatically shut off after 3 hours.
9