Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Channel
Selection
Mode
Selection
Intensity
Level
Quick Start Guide for Simple Use
1.
Snap the ELECTRODE pad into the round RECEIVER.
Note: both snaps must be attached for receiver to work.
Battery
2.
Turn the receiver on by pressing the power button.
Indicator
3.
Remove the electrode pad film and securely place the
adhesive pads directly on the skin over the pain area.
4.
Turn the REMOTE on using the On/Off switch.
5.
Choose Channel 1 or Channel 2 by pressing the
CHANNEL button on the REMOTE.
Note: Channel Selection (c) needs to match the number
on the receiver.
6.
Set the mode of the selected RECEIVER to Mode 1-4
by pressing the MODE button on the Remote.
Note: see suggested mode section for treatment suggestions.
7.
Adjust the intensity of the selected RECEIVER by
pushing the + or - button on the remote. Do this until
the sensation is comfortable.
Note: Intensity level will need to be adjusted each time
the MODE is changed.
7
Publicité
Chapitres
Table des Matières
Dépannage
