Attaching The Shoulder Strap - Dolmar PB-7601.4 Instructions D'emploi

ATTACHING THE SHOULDER STRAP

Attachment Procedure
Attaching the shoulder strap to the blower.
• Loop the end of the strap through the lower part of the hanger as shown in
the figure at right. The side of the strap that has the folded tip should be
facing outwards. Then, bring the end of the strap back over the hanger and
thread the remaining length of the strap through
the buckle (1) by pushing it towards the hanger in the direction of the arrow
shown in the drawing while pulling on the strap in the opposite direction.
• After attaching the strap, tighten the buckle to the hanger. Tug strongly at
the strap to make sure that the strap is secure and will not come undone.
• Attach the hook at the bottom of the shoulder strap to the ring on the
frame.
• Verify that the strap is not twisted.
Caution: Please make sure that strap is attached with the folded tip facing
outwards. If the strap is used with the outside of the strap facing in,
there is the risk that the strap may come loose causing the operator
to drop the blower.
the buckle (1). Tighten
9
(1)
Quick-disconnect
spring hook