Connecting The Appliance To The Power Supply - Whirlpool ACM 808 Mode D'emploi

Connecting the appliance to the power supply

Open the terminal board (see Fig. 1), unscrew the cable clamp
screw.
• Strip approx. 70 mm. of the cable sheath from the power
supply cable
• Strip approx. 10 mm. of sheath from the conductors
• Insert the cable into the cable clamp and connect the
conductors to the terminal block as indicated in the diagram
printed on the label close to the main box
• Secure the power cable by means of the cable clamp
• Close and refit the main box plastic cover
NOTE: the yellow-green earth wire must be connected to the
screw with symbol .
Installation
Important: The covering of the cabinets must be in heat
resistant (min. 90°C) material.
If the appliance is installed next to kitchen cabinets, ensure the
minimum clearances indicated in the following figure.
There are certain points to pay attention to when positioning
the cooker. Make sure to take into consideration the following
recommendations, in order to prevent any problems and
hazardous situations that may occur!
The cooker can be positioned near other cabinets provided
their height does not exceed the hob level.
In selecting a position for the cooker, make sure the appliance
is not placed next to a refrigerator and that there are no
flammable or combustible materials in the vicinity, such as
curtains, etc. which can quickly catch fire.
A minimum space of 20 mm between the metal rear cover of
the cooker and the wall is required to ensure air circulation.
If the counter tops are higher than hob level, they should be at
least 110 mm from the sides of the cooker.
To fit them, tilt the appliance and screw the 4 feet in the special
threads located in the corners (see Fig. 3).
Min. 50 cm (depending on the model)
Fig. 2
15
Fig. 1
Max.
adjustment
15 mm
Fig. 3