Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
STUDER INNOTEC
Introduction
The sine wave inverters of the AJ series have
been
designed
to
domestic needs. They meet the highest requi-
rements of comfort, safety and reliability.
Any device designed for the public electrical
network of 230 V 50 Hz can be connected to
them (up to the nominal power of the
inverter).
The AJ series is the perfect source of voltage
in any place where the public network is not
available.
This document is an essential part of the in-
verter and must always be carried with it and
be at the disposition of anyone working on the
installation.
Should you have any doubt or question, do
not
hesitate
to
salesperson who will give you the best
advice.
Note
A deficient assembly could result in damage
to the device, cause function failures or
potential damage to the users.
The working device generates a high voltage
which might be lethal in case of contact. So,
any manipulation of the inverter must be
carried out with utmost care.
THE OWNER MUST NOT MANIPULATE
ANY PIECE INSIDE THE INVERTER.
Opening the inverter or using it incorrectly will
result in the immediate loss of the warranty.
No current or tension generating device
(public grid, generator, ...) may be connected
to the outlet of the inverter because this could
result in its destruction.
English description
meet
industrial
contact
your
specialist
AJ V2.0
The inverter AJ is to be used only with a lead
battery. As for the use of batteries, follow the
manufacturer's instructions.
and
Installation
The AJ sine wave inverter is an electronic
device, for which some caution must be taken
when installing it:
Place where the inverter is to be installed:
- Out of reach of unauthorised persons,
specially children.
- In a dry place (max. 95% humidity), and in
any case with no condensation.
- Not directly on top of the batteries.
- Ventilation must be free, and a space of 10
cm. on each side is needed for good evacua-
tion of the internal heat.
Fitting the inverter
The inverter is fitted by screws (max. 4mm
for AJ 275-AJ 1300 or max. 8mm for AJ 2100
and 2400)
The fitting screws are not supplied with the
inverter. It may be fit into any position.
AJ
L L
AJ 275-400
L= 163mm
AJ 500-700
L= 240mm
AJ 1000-1300
L= 428mm
AJ 2100-2400
L= 399mm
using the four holes provi-ded.
3
Publicité
Table des Matières
