Function Turning On The Unit; Menu - PRESIDENT MC KINLEY 12V Manuel D'utilisation

11) 6 PIN MICROPHONE PLUG
The plug is located on the front panel of the transceiver and makes
the setting of the equipment into the dashboard easier.
See cabling diagram page 73.
12) PTT ~ RF POWER ~ MIC GAIN ~ TALKBACK
PTT (Push To Talk)
Transmission switch, press to transmit a message,
and release to listen to an incoming communication.
RF POWER
See § RF POWER page 43
MIC GAIN
See § MIC GAIN page 45
TALKBACK
(combination 12 / 10)
The TALKBACK function allows to ear your own modulation with
the CB speaker.
While pressing PTT switch (12),
- Press F key (10) to activate/deactivate
the function is on, "TALKBACK" is displayed.
TALKBACK LEVEL
(12 / 5)
When the TALKBACK function is on, press and hold PTT switch (12)
and turn the rotary CH knob (5) to
steps from 01 to 09.
TOT (Time Out Timer)
If the transmission (using the PTT (12) key or VOX) is more than 5
minutes, CHANNEL and
The time-out tone will sound until the PTT key is released.
13) UP/DN BUTTONS ON MICROPHONE
increase
- These buttons (13) allow
nel. A beep sound is emitted whenever the channel is changed if
the KEY BEEP function is activated (see BEEP KEY function on page
47).
is displayed
TALKBACK function. When
adjust the TALKBACK level. 9
start blinking, the transmission ends.
decrease
(UP) or (DN) the chan-
The display shows the corresponding frequency. For example
"27.205" for channel 40. See SPAN menu page 48.
See § CHANNEL SELECTOR CH on page 43.
C) FUNCTION TURNING ON THE UNIT
To select the FREQUENCY BAND turn off the unit. Press and hold
the F key (10) and then turn the unit on.
(Configuration: EU; PL; d; EC; U; In)
The frequency bands have to be chosen according to the country
of use. Don't use any other configuration. Some countries need a
user's licence. See table page 75.
1. Turn on the power while pressing the F key (10). The letter corre-
sponding to the current configuration is blinking.
2. In order to change the configuration, turn the rotary CH knob (5)
on the unit or use the UP/DN buttons (13) on the microphone.
3. When the configuration is selected, press the F key (10) during 1
second. The letter corresponding to the configuration is continu-
ously displayed and a confirmation beep sounds.
4. At this point, confirm the selection by switching off the transceiver
and then switching it on again.
See the frequency bands table at pages 70 to 72 / configu-
ration table page 74.
D) MENU
The order of the 14 functions is the one described in this manual.
However, the function displayed when entering the MENU will be
the last function modified by the user.
Whatever the function, the procedure is the same:
Press the CH knob (5) for 3 seconds to enter MENU.
1. Turn the rotary CH knob (5) or use the UP/DN buttons (13) on the
microphone to select the menu.
2. Press the CH knob (5) to confirm. The setting parameter of the
selected menu flashes in the display.
3. Turn the rotary CH knob (5) or use the UP/DN buttons (13) on the
microphone to change
46
the parameter value.
appears.