Connecting The Video Cable; Cable-Controlled Wdr Function - Abus HDCC62500 Notice D'utilisation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 49

3.4. Connecting the video cable

In order to transmit the HD-TVI video signal from the camera to a recorder, an RG59 or RG6 type
coaxial cable with BNC connector (male) must be connected to the connection labelled "TVI". The cable
length to the next device must not exceed 500 m (RG6) or 300 m (RG59).
An RG59 or RG6 type coaxial cable can be connected to the analogue video output (labelled "CVBS").
The cable length to the next device must not exceed 100 m.
Note
To ensure optimum quality of the HD-TVI signal transmission, it is important that the cable is
neither kinked nor crushed at any point, and that its radius is adequate (min. bending radius
6 cm).
Damage to the cable or porosity as a result of ageing can have a negative impact on the
quality of the signal or image (e.g. shadowing around the edges).

3.5. Cable-controlled WDR function

The wide dynamic range function enhances the image quality in the event of high contrasts in the video
image. This camera's wide dynamic range function can be activated and deactivated via an external
contact (by on-screen display, only via ABUS HD-TVI DVR).
To activate the DWDR function, connect both connections of the external contact together.
If the DWDR function is not used or is controlled by the on-screen display of the HD-TVI DVR, both
contacts should be isolated to prevent short-circuit, contact with other housing parts and electrical
potential.
38
English

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Hdcc72500

Table des Matières