Start-Up And Use; Using The Hob; Using The Oven - Indesit KN6G21/EX Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Start-up and use

Using the hob

Lighting the burners
For each BURNER knob there is a complete ring
showing the strength of the flame for the relevant
burner.
To light one of the burners on the hob:
1. Bring a flame or gas lighter close to the burner.
2. Press the BURNER knob and turn it in an
anticlockwise direction so that it is pointing to the
maximum flame setting E.
3. Adjust the intensity of the flame to the desired level
by turning the BURNER knob in an anticlockwise
direction. This may be the minimum setting C, the
maximum setting E or any position in between the two.
If the appliance is fitted with
an electronic lighting device*
(D ), press the ignition button,
X
marked with the symbol
1
knob down and turn it in
an anticlockwise direction,
D
towards the maximum flame
setting, until the burner is lit.
The burner may be extinguished when the knob is
released. If this occurs, repeat the operation, holding
the knob down for a longer period of time.
! If the flame is accidentally extinguished, switch off the
burner and wait for at least 1 minute before attempting
to relight it.
If the appliance is equipped with a flame failure safety
device*(X), press and hold the BURNER knob for
approximately 2-3 seconds to keep the flame alight
and to activate the device.
To switch the burner off, turn the knob until it reaches
•.
the stop position
Practical advice on using the burners
For the burners to work in the most efficient way
possible and to save on the amount of gas consumed, it
is recommended that only pans that have a lid and a flat
base are used. They should also be suited to the size of
the burner.
To identify the type of burner, please refer to the
diagrams contained in the "Burner and nozzle
specifications".
*
Only available in certain models.
, then hold the BURNER
Burner
Fast (R)
Semi Fast (S)
Auxiliary (A)
Triple Crown (TC)
! On the models supplied with a reducer shelf,
remember that this should be used only for the
auxiliary burner when you use casserole dishes with a
diameter under 12 cm.
WARNING! The glass lid can break
in if it is heated up. Turn off all the
burners and the electric plates
before closing the lid.
Electric hotplates*
The corresponding knob may be turned clockwise or
anti-clockwise and set to six different positions:
When the selector knob is in any position other than the
off position, the 'on' light comes on.
Setting Normal or Fast Plate
0
Off
1
Low
2 - 5
Medium
6
High

Using the oven

! The first time you use your appliance, heat the empty
oven with its door closed at its maximum temperature
for at least half an hour. Ensure that the room is well
ventilated before switching the oven off and opening
the oven door. The appliance may emit a slightly
unpleasant odour caused by protective substances
used during the manufacturing process burning away.
! We recommend cleaning the oven before using it for
the first time, following the instructions provided in the
„Care and maintenance" section.
! Never put objects directly on the bottom of the oven;
this will avoid the enamel coating being damaged.
Only use position 1 in the oven when cooking with the
rotisserie spit.
ř Cookware Diameter (cm)
24 - 26
16 - 20
10 - 14
24 - 26
GB
9

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Kn6t21s/exKn6m21/ex

Table des Matières