Olimpia splendid MIA 7,5 Instructions Pour L'installation, L'emploi Et L'entretien page 12

GB
300300
Carefully read the precautions and follow the procedures correctly.
the work area to avoid In case of breakage or poor functioning contact the Authorized Assistance Cen tre;
any attempt to remove parts or perform maintenance on the device can expose the
ruct the slits placed on user to electrical shock danger.
The stove contains parts whose maintenance must be done by qualified personnel.
The stove is a heating device; its parts reach extreme temperatures and contact wi-
works of art.
thout adequate protection can provoke burns of various degrees.
Pay particular attention to children.
t.
Do not insert ngers or other objects in the air ow exit slits.
n have negative effects
Inside the device there is a high speed fan that could cause grave personal injury.
Pay particular attention to children.
Do not remain for long periods directly exposed to the ow of hot air. Direct and pro-
in the room.
longed exposition to the cold air could be hazardous to health.
Pay particular attention in rooms where there are children, the elderly or the ill. In case
ent possibilities of elec-
the stove functions poorly, shut down the device immediately and contact the Autho-
rized Assistance Centre.
The continued use of the device in said conditions can cause res or ashes.
lower screen will read
g and ordinary mainte-
long periods of time.
Norms and conformity declarations
environments that are ad-
on.
Legislation
connect devices different
• Our company declares that the stove conforms to the following norms for EC European
Directive marking.
r electrical system usage
• 2004/108 EC (EMC directive) and successive amendments.
• 2006/95 EC (low voltage directive) and successive amendments.
ch collects solid material
• Regulation of the CPR (EU 305/2011).
ance to the ue so that it
• For installation in Italy refer to the UNI 10683/98 or successive modi cations; the te-
chnician installing the hydrothermal sanitary system will issue the declaration of con-
formity according to L. 37/2008. The installation of appliance has to be in accordance
with local and national laws and with European norms.
• EN 55014-1; EN 55014-2; EN 61000-3-2; EN 61000-3-3; EN 60335-1;
EN 60335-2-102; EN 62233; EN 14785; EN 50581.
Responsibility
The manufacturer declines every direct or indirect, civil or penal responsibility due to:
• Poor maintenance.
• Failure to observe the instructions contained in the manuals.
• Use in non-conformity with the safety directives.
• Installation in non-conformity with the norms in force in the country.
• Installation by unquali ed or untrained personnel.
• Modi cations and repairs not authorized by the manufacturer.
• Use of non-original replacement parts.
• Exceptional events.
Use of unsuitable pellets
•
Installation
Flue
The ue must meet the following requirements:
• No other type of chimney, stove, boiler or hood vent must be connected ( g.1).
• It must be adequately distanced from combustible or in ammable material by means
of an air cavity or opportune insulation.
• The internal section must be uniform, preferably circular: the square or rectangular
sections must have rounded corners with a radius of no less than 20 mm, a maximum
relationship between the sides of 1.5; the walls as smooth as possible with no narro-
wed sections, regular curves and no discontinuities, with deviations from the axis not
more than 45°.
• Every device must have its own ue with a diameter equal to or larger than the stove's
smoke clearing tube and a height not less than that declared.
• Never use two stoves, a chimney and a stove, a stove and a wood kitchen, etc in the
same environment, since the draught of one could damage the draught of the other.
• Collective type ventilation ducts that can lower the atmospheric pressure in the in-
Installation manual
WARNING! WARNING!
During the stove installation operation, keep children out of the work area to avoid
unforeseen accidents.
Do not block or cover in any way the body of the stove or obstruct the slits placed on
the upperside.
Obstructing said slits can cause res.
Do not use the stove in areas containing precision devices or works of art.
The quality of the conserved objects may deteriorate.
Do not expose animals or plants to direct air ow from the unit.
Prolonged direct exposition to the ow of air from the stove can have negative effects
on plants and animals.
Occasionally ventilate the room during the use of the device.
Insuf cient ventilation can be the origin of insuf cient oxygen in the room.
Do not expose the stove to contact with water.
The electrical insulation could be damaged, with the consequent possibilities of elec-
trocution and breakage due to the thermal extremes.
Verify the installation conditions to locate eventual damage.
After the stove has completed 900 hours of operation (the lower screen will read
"SErV"), contact the Authorized Assistance Centre for cleaning and ordinary mainte-
nance.
Do not use in ammable gas near the stove.
Unhook the automatic switch if the device will not be used for long periods of time.
We check the start up of all our stoves.
stallation environment are not permitted, even if installed in environments that are ad-
jacent to and communicating with the locale of the installation.
• It is forbidden to make xed or mobile openings in the ue to connect devices different
from that for which it is originally intended.
• It is forbidden to pass other air feeding channels or tubes for electrical system usage
through the ue, even if oversized.
• It is advisable that the ue be furnished with a chamber which collects solid material
and eventual condensation situated below the vertical entrance to the ue so that it
NO
YES
Fig.1: methods for installing the ue
11 10
GB
NO