cecotec CONGA 4090 Manuel D'instructions page 36

ENGLISH
1. Auto mode
Press on the remote control for it to start cleaning automatically, first a cleaning cycle in
Edge mode and then another cycle in and organized zig zag motion,
recognizing which areas it has cleaned and which ones it has not.
The robot will plan the cleaning route automatically as it is
cleaning. If during this mode the robot is controlled manually,
the robot will calculate the route again and could go through
previously cleaned areas. In order to ensure efficient cleaning, do not operate it manually
during auto mode cleaning.
Thanks to its TotalClean 2.0 technology, if the battery is low during the cleaning cycle, the
robot will smartly return to the charging base automatically and, once it is fully charged, it will
resume the cleaning process from the same point, offering a high-efficiency cleaning.
During cleaning, the robot will stop briefly to evaluate the area and calculate the cleaning
route (this stop will vary depending on the house conditions).
Warning: The robot cleans in an organized way and per squared 4 x 4 m areas, therefore it
might leave the room where it is cleaning to finish off the delimited area. Do not worry about
this, the robot will clean all the accessible surface.
2. Edge mode
Press the on the remote control for the robot to start
cleaning under this mode. It will automatically start cleaning
along all the surface's perimeters and then will return to the
charging base direct and automatically. If the robot has not
started cleaning from the charging base, it will return to the
starting point.
Note: press the POWER button to switch between the 3 modes
Turbo/Normal/Eco.
3. Back-home mode
Press the be activated during any other cleaning cycle and the robot will automatically
return to the charging base and stop the cleaning process. The robot will take the shortest route
back to the charging base thanks to its map memorizing and the smart back-home function.
When a cleaning cycle has been completed or the robot's battery
is low, thanks to its TotalClean 2.0 technology, the robot will also
return to the charging base to avoid running out of battery. Once
the robot has recharged, it will resume cleaning from the exact
point it has stopped.
35