Main Broom Disassembly/Assembly - Nilfisk SW 750 Instructions D'utilisation

MAIN BROOM DISASSEMBLY/ASSEMBLY

CAUTION!
It is advisable to wear protective gloves when
replacing the main broom because there can be
sharp debris between the bristles.
1. Drive the machine on a level fl oor.
2. Turn the main switch (1) to "0".
3. Remove the hopper (9).
4. Loosen the handwheels (A, Fig. 5) completely on the left
side of the machine.
5. Remove the lid (A, Fig. 6) by grasping it on the points (B).
6. Grasp the main broom (A, Fig. 7) on the points (B) and
(C), then disconnect it from the drive hub (D) by pulling it in
the direction shown by the arrow (E); then remove it in the
direction shown by the arrow (F).
7. The new main broom must be installed with the bristles
rows bent as shown in the fi gure.
8. Install the new broom by performing steps 3 to 6 in the
reverse order.
9. Adjust the new broom height as shown in the previous
paragraph.
D
C
F
E
Figure 7
SW 750 146 3080 000(2)2008-08 A
USER MANUAL
A
Figure 5
A
B
Figure 6
A
ENGLISH
S311354
S311355
B
S311356
13