Preparation Of The Coating Material; Preparation Of The Workplace (For Interior Wall Paint) - WAGNER WallPerfect Flexio 995 Mode D'emploi

WallPerfect Flexio 995 WallPerfect Flexio 995

8. Preparation of the Coating Material

Mix the material well in the original container. When using interior wall paint, an agitator
is recommended.
WallPerfect Flexio 995 has been developed for use with all conventional paints in
i
their undiluted form. If the surface is smooth and the paint you are using is very
thick and gel-like, dilute it by 10%. Dilution can be necessary if the atomisation
is coarse or if the flow rate is too low even at the maximum setting.
Detailed information about the various materials and the maximum permitted
dilution can be found on the manufacturers' technical data sheets (e.g. available
on the Internet).
Spray material that is at least at room temperature provides a better spray
i
result.
The following chapters 9-19 discuss using the Flexio 995 as a wall paint
i
spraying system.
Read chapters 20-26 if you want to use varnish paints and glazes with the
Flexio 995.

9. Preparation of the workplace (for interior wall paint)

Sockets and plugs must be masked. Risk of an electric shock as a
consequence of sprayed material entering the socket!
Mask all the areas and objects that are not to be spray painted, or
remove them from the work area. No liability is assumed for damage
due to overspray. Silicate paint corrodes glass and ceramic surfaces
upon contact! All such surfaces must therefore be completely covered.
Pay attention to the quality of the adhesive tape used.
i
Do not use excessively strong adhesive tape on wallpaper and painted
surfaces, in order to avoid damaging these surfaces when removing the
tape. Remove adhesive tape slowly and evenly; do not use jerky movements.
Do not leave adhesive tape on surfaces any longer than necessary, in order
to minimise the possibility of residues when removing.
Also observe the adhesive tape manufacturer's instructions.
GB D
39 39