Changing The Wireless Display Settings - Panasonic CF-VDW07CH Mode D'emploi

Changing the Wireless Display Settings

Wireless Display Setup Utility
When adding the check
mark here, the MeiWDS
profile setting (one profile
only), such as the pass-
word or AES Encryption,
is also set to the computer
connected to the wireless
display.
You can set the wireless display properties as follows.
1 Select [Wireless Display Setup Utility] in the following
procedure.
Windows XP
[start] - [All Programs] - [Panasonic] - [Wireless Display
Setup Utility]
Windows 2000
[Start] - [Programs] - [Panasonic] - [Wireless Display
Setup Utility]
2 Enter the Supervisor Password.
The Supervisor Password is not set at the time of the pur-
chase.
Press the Menu button, select [Option], then set the Su-
pervisor Password. (
3 Set the wireless display settings, TCP/IP and WEP.
You can set them for each profile.
Change the profile name.
Change AES Encryption.
<When setting AES Encryption to something other than
[Disable]>
Select [Key], and set AES Key using phrase or binary,
then select [OK].
Change WEP Encryption.
<When setting WEP to something other than [Disable]>
Select [Key(s)], and set WEP Key(s), then select [OK].
When [Network Type] is set to [Infrastructure] and [WEP]
is set to [64 bits] or [128 bits], the check mark can be
added for or removed from [Shared Key Authentication].
When removing the check mark from [Shared Key
Authentication]:
"Open mode" is enabled.
When adding the check mark for [Shared Key Au-
thentication]:
"Shared mode" is enabled.
After finalizing the settings, select [Next], then select [OK].
(If another screen is displayed after selecting [OK], se-
lect [OK].)
page 33)
E
35