HQ Power VIPER 250 Mode D'emploi page 4

e) Mounting the Device
• Have the device installed by a qualified person, respecting EN 60598-2-17 and all other applicable norms.
• The carrying construction must be able to support 10 times the weight of the device for 1 hour without deforming.
• The installation must always be secured with a secondary attachment e.g. a safety cable.
• Never stand directly below the device when it is being mounted, removed or serviced. Have a qualified technician
check the device once a year and once before you bring it into service.
• Install the device in a location with few passers-by that is inaccessible to unauthorised persons.
• Overhead mounting requires extensive experience: calculating workload limits, determining the installation
material to be used... Have the material and the device itself checked regularly. Do not attempt to install the
device yourself if you lack these qualifications as improper installation may result in injuries.
• Adjust the desired inclination angle via the mounting bracket and tighten the bracket screws.
• Make sure there is no flammable material within a 0.5m radius of the device.
• Have a qualified electrician carry out the electric connection.
• Connect the device to the mains with the power plug. Do not connect it to a dimming pack.
• The installation has to be approved by an expert before the device is taken into service.
f) Replacing the fuse
• If the lamp burns out, the fuse of the device might fuse, too.
• Only replace the fuse by a fuse of the same type and rating.
• Before replacing the fuse, unplug mains lead.
1) Unscrew the fuse holder on the rear panel of the base with a fitting screwdriver from the housing.
2) Remove the old fuse and install the new fuse in the fuse holder.
3) Replace the fuse holder in the housing and fix it.
5. Use
a. The moving head is controlled by 16 DMX channels:
CHANNEL 1 : pan movement (max. 530°)
CHANNEL 2 : tilt movement (max. 280°)
CHANNEL 3 : pan fine
CHANNEL 4 : tilt fine
CHANNEL 5 : speed of pan/tilt movement
CHANNEL 6 : lamp on/off & reset
CHANNEL 7 : Colour 1
CHANNEL 8 : static gobo / colour 2
CHANNEL 9 : prism
CHANNEL 10 : 3-facet prism rotation
CHANNEL 11 : rotation gobos
CHANNEL 12 : rotating gobo index, gobo rotation
CHANNEL 13 : zoom, frost and UV filter
CHANNEL 14 : focus
CHANNEL 15 : shutter, strobe
CHANNEL 16 : dimmer intensity
b. Detailed DMX values per channel:
CHANNEL 1
CHANNEL 2
CHANNEL 3
CHANNEL 4
CHANNEL 5 Speed of PAN / TILT movement
VDP250MHS16
Description From
PAN
TILT
PAN FINE
TILT FINE
To Function
0 255 530° Rotation
0 255 280° Rotation
0 255 Fine control of PAN movement
0 255 Fine control of TILT movement
0 255
4
Slow / Fast
VELLEMAN