Control Lock; Cooktop Use; Sealed Surface Burners - Whirlpool WFG550S0HV0 Instructions D'utilisation

Keypad Feature
COOK TIME Timed cooking
CLEAN Self-Cleaning
cycle

CONTROL LOCK

Oven and
(Hold 3 sec) cooktop control
lockout
WARNING
Fire Hazard
Do not let the burner flame extend beyond the edge of
the pan.
Turn off all controls when not cooking.
Failure to follow these instructions can result in death
or fire.
Electric igniters automatically light the surface burners when
control knobs are turned to
Before setting a control knob, place filled cookware on the
grate. Do not operate a burner using empty cookware or
without cookware on the grate.
To Set:
1. Push in and turn knob counterclockwise to the Ignite position.
IMPORTANT: All four surface burners will click. Only the
burner with the control knob turned to the Ignite position will
produce a flame.
2. Turn knob to anywhere between Hi and Lo.
REMEMBER: When range is in use or (on some models)
during the Self-Cleaning cycle, the entire cooktop area may
become hot.
6
Instructions
Cook Time allows the oven to be set to turn on at a certain time of day, cook for a set length
of time, and/or shut off automatically.
To set a Timed Cook or a Delayed Timed Cook, see "Cook Time" section.
See the "Self-Cleaning Cycle" section.
1. Check that the oven and cooktop are off.
2. Press and hold CONTROL LOCK for 3 seconds.
3. A tone will sound and a lock will be displayed.
4. Repeat to unlock. No keypads will function with the controls locked.

COOKTOP USE

(Ignite).
Power Failure
In case of prolonged power failure, the surface burners can
be lit manually. Hold a lit match near a burner and turn knob
counterclockwise to the Ignite position. After the burner lights,
turn knob to setting.

Sealed Surface Burners

A
B
C
A. Burner cap
B. Burner base
C. Alignment pins
IMPORTANT: Do not obstruct the flow of combustion and
ventilation air around the burner grate edges.
Burner cap: Always keep the burner cap in place when using
a surface burner. A clean burner cap will help avoid poor ignition
and uneven flames. Always clean the burner cap after a spillover
and routinely remove and clean the caps according to the
"General Cleaning" section.
Gas tube opening: Gas must flow freely throughout the gas tube
opening for the burner to light properly. Keep this area free of soil
and do not allow spills, food, cleaning agents, or any other
material to enter the gas tube opening. Keep spillovers out of
the gas tube by always using a burner cap.
A
A. 1-1
B. Burner ports
Burner ports: Check burner flames occasionally for proper size
and shape as shown in the previous illustration. A good flame
is blue in color, not yellow. Keep this area free of soil and do not
allow spills, food, cleaning agents, or any other material to enter
the burner ports.
D
E
D. Igniter
E. Gas tube opening
B
/ " (2.5-3.8 cm)
1
2