Assembly Model Tx501; Assembly Model Tx502 - Texas TX-501 Manuel De L'utilisateur

Assembly model TX501

1. Figure 1 shows the contents of the box:
a. Cultivator with clutch handle and cables.
b. Blades
c. Lower part of handle bar
d. Side guards
e. Manual with bolt set
f. Upper handle bar
g. Debth skid
h. Cable clips
i. Bumper
2. Assemble the equipment using the bolts and locknuts supplied.
Figure 2a.
3. Fit handlebar using the bolts and hand wheel supplied.
Figure 3.
4. Fit the clutch handle on the right handle, and throttle handle, as shown in figure 10.
5. Fasten the cables using the cable clips supplied.
6. Fit the side guards using the bolts and nuts supplied.
Figure 4.
7. Fit the bumper using the bolts and nuts supplied
Figure 5.
8. Fit the blades using the split pins supplied.
Make sure the cutting edge of the blade faces forward, as shown in figure 6A.
Alternatively, see figures 5 and 6.
9. Fill oil and fuel as instructed in the motor's instruction manual.

Assembly model TX502

1. Figure 7 shows the contents of the box:
a. Cultivator with clutch handle and cables.
b. Upper handle bar
c. Blades
d. Bumper
e. Cable clips
f. Side guards
g. Earth rod
h. Manual with bolt set
2. Fit the handlebar with the factory-supplied bolts and hand wheel. Make sure the bolt
goes through the spring.
Figures 8 and 9.
3. Fit the clutch handle on the right handle, and throttle handle, as shown in figure 10.
12