Taurus Cayenne 2000 Mode D'emploi page 14

Use:
- Take the length of cable required
out of the housing.
- Connect the appliance to the mains.
- Turn the appliance on using the on/
off switch.
Electronic power control:
- The power of the appliance can be
regulated by using the power regula-
tor control. This function is very use-
ful, as it makes it possible to adapt
the power of the appliance to the type
of work that needs to be done.
Once you hace finished using the
appliance:
- Turn the appliance off, using the on/
off switch.
- Unplug the appliance to the mains.
- Retract the cable by pressing the
roller cable button and guide the
cable into the appliance.
Carry handle/s:
- The device has a handle on the
upper part so it can be transported
easily and comfortably.
Parking position:
- To use the horizontal parking
position, fix the break pad hook to the
hook situated on the rear side of the
appliance (Fig. 3).
Safety thermal protector:
- The appliance has a safety device,
which protects the appliance from
overheating.
- If the appliance turns itself off and
does not switch itself on again, dis-
connect it from the mains supply, and
Manual Cayenne.indb 14
wait for approximately 15 minutes
before reconnecting. If the machine
does not start again seek authorised
technical assistance.
Cleaning
- Disconnect the appliance from the
mains and let it cool before underta-
king any cleaning task.
- Clean the equipment with a damp
cloth with a few drops of washing-up
liquid and then dry.
- Do not use solvents, or products
with an acid or base pH such as blea-
ch, or abrasive products, for cleaning
the appliance.
- Do not submerge the appliance in
water or any other liquid, or place it
under a running tap.
Emptying the dust box:
- Empty the vacuum deposit when
dust is visible though the transparent
walls, when it is full, or when the
vacuum cleaner does not work to its
full potential.
- Disconnect the hose from the
vacuum cleaner's air intake.
- Disconnect the dust box from the
appliance. (Fig. 4)
- Open the lid of the dust box and
empty the contents into the appro-
priate waste disposal receptacle.
- Check the condition of the dust box
filter.
- Check the condition of the motor
filter.
- Close the lid of the dust box.
- Attach the dust box to the applian-
ce.
21/03/11 10:36