Cleaning The Spray Arms; External Cleaning; Troubleshooting; Alarm Code - Electrolux ESF6210LOK Notice D'utilisation

28 www.electrolux.com

8.2 Cleaning the spray arms

Do not remove the spray arms.
If the holes in the spray arms are clogged,
remove remaining parts of soil with a thin
pointed object.

8.3 External cleaning

Clean the appliance with a moist soft
cloth.

9. TROUBLESHOOTING

The appliance does not start or it stops
during operation.
Before you contact the Service, refer to
the information that follows for a solution
to the problem.

Alarm code

• The end indicator flashes 1 time in-
termittently.
• Start indicator flashes continuously.
• The end indicator flashes 2 times in-
termittently.
• Start indicator flashes continuously.
• The end indicator flashes 3 times in-
termittently.
• Start indicator flashes continuously.
2. To disassemble the filter (A), pull
apart (A1) and (A2).
3. Remove the filter (B).
A1
4. Wash the filters with water.
5.
Put the filter (B) to its initial position.
Make sure that it assembles correctly
under the two guides (C).
A2
6. Assemble the filter (A) and put it into
position in filter (B). Turn it clockwise
until it locks.
Only use neutral detergents. Do not use
abrasive products, abrasive cleaning pads
or solvents.
With some problems, the end indica-
tor flashes intermittently to show an
alarm code.
Problem
The appliance does not fill with water.
The appliance does not drain the water.
The anti-flood device is on.
An incorrect position of the filters
can cause bad washing results
and damage to the appliance.