Table des Matières
Publicité
Anleitung BDS 180-2 SPK1
Please read the operating instructions carefully and
observe the safety regulations at all costs. Keep the
operating instructions together with the triangular
sander.
1. Safety rules
The corresponding safety information can be found in
the enclosed booklet.
2. Technical data
Voltage:
230 V ~ 50 Hz
Power rating:
Oscillations per minute:
Sound pressure level:
Sound power level:
Protection class:
Vibration a
:
w
Tool weight:
Sanding paper dimensions:
90 x 90 x 90 mm
3. Putting into operation
Take the sanding paper and place it on the sanding pad.
Make sure that the dust extraction holes coincide. Fix the
sanding paper in position by pressing firmly (with your hand).
Check the mains voltage: The voltage of your power source
must be the same as that specified on the tool's rating plate.
SWITCHING ON/OFF
To switch on, simply move the switch at the bottom of the
tool from 0 to 1.
4. Replacing the sanding paper
The sanding pad features Velcro-type backing for fast fixing
of the sanding paper without a mechanical clamping device.
Before you attach new sanding paper, remove all dust from
the sanding pad by tapping and cleaning with a brush or
compressed air.
5. Dust extractor
The dust extractor prevents
serious soiling and high
dust levels in the air your
breathe, and it also makes
it easier to dispose of the
waste dust.
6. Cleaning, maintenance and ordering of
spare parts
Always pull out the mains power plug before starting any
cleaning work.
05.04.2006
11:08 Uhr
Seite 3
6.1 Cleaning
Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it
with compressed air at low pressure.
We recommend that you clean the device
immediately each time you have finished using it.
Clean the equipment regularly with a moist cloth
and some soft soap. Do not use cleaning agents
or solvents; these could attack the plastic parts of
the equipment. Ensure that no water can seep
into the device.
Keep the extraction holes in the oscillating plate clean.
If you discover that the machine has a defect in spite of it
180 W
having been manufactured and tested with all due care,
8.000
have the machine repaired by a specialist.
72,3 db(A)
6.2 Carbon brushes
83,3 dB(A)
® /
In case of excessive sparking, have the carbon brushes
II
checked only by a qualified electrician.
< 2,5 m/s
2
Important! The carbon brushes should not be replaced
1.2 kg
by anyone but a qualified electrician.
6.3 Maintenance
There are no parts inside the equipment which
require additional maintenance.
6.4 Ordering replacement parts:
Please quote the following data when ordering replacement
parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required
For our latest prices and information please go to www.isc-
gmbh.info
7. Notes on working with the machine
The triangular sander is particularly efficient at sanding hard-
to-reach corners and edges. It is possible to work with just
the tip or one edge of the sanding disk when sanding profiles
and flutes. Assorted grades of sanding paper are available
to suit the workpiece material and the depth of surface
removal required. The intensity of sanding depends mainly
on your choice of sanding paper and the controlled pressure
you apply to the sanding disk.
8. Environmental protection
Remember that waste prevention is better than waste
disposal.
Dispose of packaging, accessories, defective components
and machines in an environment-friendly manner, i.e.
classify and recycle.
Ask you local council offices for advice.
GB
3
Publicité
Table des Matières
