REMIS REMIcare Van Notice De Montage page 10

A15
US/GB
A16
A17
A18
A19
10/17
A15:
Close the insect protection door and mark the position of
the top guiding profi le's end cap resulting from this. Make
sure to let the guiding rail run parallel to the door sealing.
A16:
Bring the insect protection door back into idle position and
screw the top guiding rail onto the marked position using
the 3.5x16mm panhead bold (B).
A17:
Then attach the fi xation backet to the furniture construc-
tion. Depending on the furniture construction screw length
may vary. Select the panhead bolt 3.5mm (C) length ac-
cordingly. In order to adjust the fi xation bracket loosen the
screw a bit and position the bracket at the desired height.
Now pull the screw tight again.
A18:
Now correct the position of the shutter, if necessary. Make
sure the whole section between coffer and door sealing is
covered.
Now screw the coffer onto the bar the shutter has been
inserted into, onto the furniture construction. Depending
on the furniture construction screw length may vary. Select
the 3.5mm panhead bolt (C) length accordingly.
A19:
Exchange the two top screws of the door mount with the
two cylinder screws M8x25 complying with DIN 6912-8.8
(fl at head). In order to not change the adjustment of the
door exchange the screws one after the other.