The Package Contains; Assembly Procedure; Installation Requirements - Quick THG 512 Manuel De L'utilisateur

THE PACKAGE CONTAINS:

manual - Conditions of warranty.
TOOLS REQUIRED FOR INSTALLATION:
hexagonal wrenche: 6 mm.
"QUICK "ACCESSORIES RECOMMENDED:
®
hand helds R/C (mod. HRC1002) - Foot switch (mod. 900) - Hydraulic-magnetic circuit breaker - Radio control RRC (mod. R02,
PO2, H02).

ASSEMBLY PROCEDURE:

below deck to perform the installation in the lower part. The thickness of deck must be such as to allow the capstan to be se-
curely placed in position.

INSTALLATION REQUIREMENTS:

lower surfaces of the deck are as parallel as possible. If this is not
the case, compensate the difference appropriately (a lack of par-
allelism could result in a loss of motor power). The deck thickness
must be included among the figures listed in the table. In cases of
other thicknesses it is necessary to consult a Quick
ASSEMBLY:
when the ideal position has been established, drill
four holes using the drilling template provided. Place the capstan
and fasten it by screwing the nuts on the fixing stud bolts. Connect
the supply cables from the capstan to the reversing contactor unit.
Follow these steps to install the strap-roller on the sprocket:
Unscrew the screws (7) using a 6-mm Allen wrench; remove the base
plate (6) and pay attention to the pins (16) which must be fitted back;
unscrew and remove the screw (22).
Then fix the strap-roller by threading the screw (22) through the end
loop of the strap-roller.
Refit all the parts that were removed.
WARNING:
before wiring up, be sure the electrical cables
are not live.
THG 500 - REV000A
Capstan - Reversing contactor unit - Bolts and screws (for assembly) - Drill template - User's
drill and drill bit: Ø 11 mm (23/64"); fork or polygonal key 17 mm (43/64");
strap-roller with spring catch - Windlass control board (mod. 800) - Watertight
the following parts are to be checked before the holes are drilled. There must be no obstacles
ensure that the upper and
retailer.
®
INSTALLATION
22
STRAP-ROLLER
GB
6
16
7
7
9