Installation And Maintenance - THOMSON THFP93510 Manuel D'utilisation

and use the small pusher (10) for easier operation.
If the food shape is big such as
put the food in, close the c
with small pusher (10) locked on it for
DO NOT be violent while pushing the ingredients in feed chute by
pusher. It is best to cut a large food into smaller pieces to fit more
easily into the chute.
It is recommended to lower the speed when slicing soft foods to avoid
tampering.
- Blender jar (20-21)
Standard processing time is l minute.
Prepare the ingredients and put them in the blender jar (20), mount
the blender cover (21)
Position the blender jar (20. 21) on motor base; turn clockwise to make
it fixed firmly. Aware that
2-3 times as pre-blending. Then choose
the operation,
water or any other ingredients
DO NOT open the blender cover (21) for adding ingredients during operation!
Always add in some water when
Tips and Warning
Please always operate the appliance according to above instruction
manual to avoid reducing the product life due to

INSTALLATION AND MAINTENANCE

- Installation
1. Position the motor base (2) on a flat and dry board.
Position the processing bowl (3) onto motor base, turn
2.
it fixed firmly.
Place driving
3.
Open the blade box (l l) of the motor base and take the blade
4.
you want. For example,
blade (12), just seat it in driving shaft (4);
well.
switch
you can take out the small lid on blender cover (21) and add
shaft (4) onto the rotor inside the bowl, seat it
when
potato, please open the chute cover,
over, and then use the big pusher (9)
operation.
should be in "0"
"1" or "2" speed
you want through the feeding hole.
using the blender.
using the chopping blade (13) or dough
when
EN-10
speed, plug in and use pulse
for processing. During
working overtime.
clockwise
using slicing or
to make
vertically.