Battery And Charger - Columbus McKinnon Pfaff HU ES 10 A Mode D'emploi

Scissor pallet truck HU ES 10 A
English
Picking up a load
Check that the load does not exceed the loading capacity (max. 1000 kg) of the Electric-Scissor pallet truck.
Each time check with the currently loading diagram. You can find an illustration of the diagram on the pallet
truck.
Roll the Electric-Scissor pallet truck slowly up to the pallet/load. Roll the fork prongs under the pallet until the
back end of the fork rests against the load (pallet). Lift the load by pressing the button "UP".
Loading diagram
Moving with the load
As the Electric-Scissor pallet truck is not equipped with a brake it must not be used on upward or downward
slopes. As far, as floor/ground clearance permits, the load should be transported across the floor/ground at
lowest height as possible (max. 300 mm).
Move at a uniform speed appropriate to the load and floor/ground conditions.
Setting the load down
Stop just before the stacking area and lift the load in safe distance over the pile.
Manoeuvre the load directly above the pile. Lower the load until fork arms are discharged.
Ensure safe reversing, move away and lower the fork arms.

Battery and Charger

Battery Voltage is 12 V / 65 Ah
The maximum charge current of the charger is 8 A.
The input / output voltage of the charger is AC 220 V / DC 12 V.
Safety regulations for handling acid batteries.
Prior to working on the battery, the vehicle must be parked secured.
Due to short circuiting no metal objects are placed on the battery.
Service people:
Read carefully the instructions of use and maintenance, given by the company manufacturing the battery.
General Rules and Advice for Operation
Above all, the battery manufacturer's directions and instructions are applicable. Modern batteries require little
maintenance and are easy to maintain. The working life of the battery depends mainly on the manner of
application and maintenance. To ensure longest possible working life, observe the following rules:
 Do not retain discharged batteries. Recharge as soon as possible.
 Avoid heavy discharge of more of 80% of nominal capacity.
 Always keep the battery clean and dry and protect against soiling.
 Be sure pole terminals and cable lug of battery are clean, covered slightly with grease, and are
tightened.
 Trained and competent personnel should only execute repairs on the battery and charging device.
 After having completed the charging process, the stacker has to remain in a ventilated room until all
gasses have safely escaped. Avoid handling the electric installation during charging time.
Disposal of the battery:
Please follow carefully national laws and recommendations concerning protection of environment of your
country. Follow battery manufacturer recommendations on this purpose.
technische Änderungen vorbehalten
The load must be evenly
distributed across both
prongs of the fork.
The load centre must not be
exceeded.
Danger of tipping over!!
design changes under reserve
F 08.01.151
changements techniques sous réserve
10 / 20