Replacing The Light Bulbs; If You Encounter A Problem - Siemens LF259RB51 Notice De Montage Et Mode D'emploi

Caution! Ensure that kitchen is
adequately ventilated. Avoid naked
flames.
Clean the operating buttons with a
mild soapy solution and soft, damp cloth
only.
Do not use stainless-steel cleaner to clean
the operating buttons.
Stainless Steel surfances:
Use a mild non abrasive stainless
steel cleaner.
Clean the surface in the same
direction a sit has been ground and
polished.
Aluminium and plastic surfaces:
Do not use dry cloths.
Use a mild window cleaning agent.
Do not use aggressive, acid or caustic
cleaners.
Observe the warranty regulations in the
enclosed service booklet.

Replacing the light bulbs

Defective LED lights must only be
replaced by the manufacturer, their
customer service department or a licensed
technician (electrician).

If you encounter a problem

If a or appears in the display:
See "Filters and Maintenance"
Section.
If it is not possible to operate the
extractor hood:
Disconnect the extractor hood from
the mains electricity supply by pulling
out the plug or switching it off at the
main fuse box. Wait for approx. 1
Minute and then switch it on again.
If the lights of the lamps is weak when the
hood is in stand-by, then invert the plug
(invert phase with neutral).
If you have any questions or if a fault
occurs, please call Customer Service.
(see list of Customer Service
representatives).
When you call please quote the following:
E-Nr.
Enter the relevant numbers into the box
above. The E-Nr. (Product no.) and FD
(Production date) are shown on the
nameplace which can be seen inside the
extractor hood after the filter frame has
been detached.
The manufacturer of the extractor
hood accepts no liability for complaints
which can be attributed to the design
and layout of the pipework.
FD
19