Operation - Festool DOMINO XL DF 700 EQ Guide D'utilisation

on the workpiece edge, thus allowing safer guid-
ance of the machine.
Secure the contact surface widening device us-
ing the two screws [10-2] on the threaded holes
[10-3] of the guide frame.
The contact surfaces of the contact surface wid-
ening device [10-5] and the table [10-4] must be
level.
10
10-1 10-2
Please observe all mentioned safety informa-
tions and the following rules when working:
– Always secure the workpiece in such a manner
that it cannot move while being processed.
– Always hold the machine with two hands on the
handles [1-3] when performing work. This re-
duces the risk of injury and is a prerequisite for
precise work.
– Close the clamp lever for routing height adjust-
ment [1-14] and the clamp lever for angle adjust-
ment [1-12] to avoid unintentional loosening
during operation.
10-3
10-4
10-5

Operation

– Adapt the feed rate to the cutter diameter and
material. Work with a constant feed rate
– Only lay the machine aside when the cutter has
come to a complete standstill.
– Always connect the machine to a dust extractor.
15