Starting The Dishwasher - Bosch SHE66C Guide D'entretien Et D'utilisation

Operating the Dishwasher
Auto
Takes the guesswork out of cycle selection! The
sensors in the dishwasher automatically adjust
the cycle length, temperature and water changes
based on the soil load. The Auto Cycle is used for
a mixed load of dishes.
Regular
Thoroughly cleans large loads having loosely
attached normal soiling.
To avoid damage to delicate or heirloom
items do not wash them in your dishwasher.
Delicate/Economy
For delicate or heirloom dishwasher and
silverware or other special items. Always make
sure that the items are dishwasher safe. Refer to
the Materials section of this manual for further
information. Hand washing may be the best
treatment of such items.
Quick Wash
For lightly soiled items with easy to remove food
soils.
Rinse and Hold
Allows you to rinse the food soil off of a partial
load and hold them in the dishwasher until there
is a full load.
More information on dishwasher cycles is located
in the Wash Cycle Information section of this
manual.
Selecting Wash Cycle Options
Available Options
SHE66C
x
SHX56C
SHV56C
x
SHX57C
SHV57C x
SHY56A
SHE58C
Pre Soak
To activate, select the Pre Soak button in addition
to one of the cycles listed above. When Pre Soak
is selected, heated water is distributed over the
dishes to allow hard to remove soils to loosen
before the actual wash begins.
x
x
x
x
x
x
x
(continued)
Half Load
In the Power Scrub Plus, Regular and Auto
Wash cycles you can reduce the energy and
water consumption when washing small, lightly
soiled loads that fill approximately half of the
dishwasher's capacity. To activate, select the Half
Load button in addition to the Power Scrub Plus,
Regular or Auto Wash cycle button.
Top Rack Only
This option allows you to save energy and water
by washing loads small enough to fill only the top
rack. To activate, select the Top Rack Only button
in addition to one of the cycles listed above.
When using the Top Rack Only feature, dishes
should only be loaded in the top rack.
OptiMISER™
This feature reduces the cycle time by
approximately 30 percent in the Power Scrub
Plus, Regular and Delicate/Economy cycles.
Cycle Progress Indicator (Models SHE58C
and SHE66C only)
On select models, the front display with show the
wash cycle progress.
Your dishes are being cleaned.
Your dishes are being rinsed.
Your dishes are being dried.

Starting the Dishwasher

Open the dishwasher door far enough to expose
the control buttons.
Press the On/Off button.
Press the button for the desired wash cycle.
Shut the dishwasher door.
The dishwasher will start automatically and
continue operating until the end of the selected
cycle.
Once you start the dishwasher, leave the
dishwasher door shut until it finishes the cycle.
Hidden Top Controls
1) Open the door
2) Turn on
4) Close the
door to start
3) Select a cycle
Figure 26
11