Starting The Dishwasher - Bosch SHV99A13UC Manuel D'utilisation Et D'entretien

Operating the Dishwasher
Standard Programs
The wash cycles available in this hidden menu
are special wash cycles that may be used to
solve special needs in the field.
NOTE: In the Options Step Down Menu you can
return to the main menu at any time by pressing
the START button.
1. Open the dishwasher door far enough to
expose the control panel.
2. Press the ON/OFF button.
3. Press the MENU/OK button seven times to
display the screen "STANDARD
PROGRAMS".
4. After the "STANDARD PROGRAMS" screen
is displayed, press the + button one time to
display available wash cycles. Those cycles
are:
· Regular – normal wash cycle.
· Enviro Care – reduces water and energy
consumption.
· Glass Care – reduces temperatures to
reduce glass damage.
· Extreme Wash - for extremely hard to
remove food soils.
5. Press the + or – buttons until the desired
wash cycle is displayed.
6. When the desired setting is displayed, press
the START button and close the door to
begin the cycle.

Starting the Dishwasher

When the correct cycle and options are shown in
the display window and you have added
detergent and rinse agent as explained in the
Adding Detergent and Rinse Agent section of
this manual, press the START button and close
the door.
After pressing the START button, the display will
show the following information:
·
"Close the door".
·
Estimated completion time (this estimated
time automatically adjusts throughout the
cycle based on incoming water temperature
and selected options).
·
Current cycle name.
12
(continued)
·
"Return" (allows you to choose another
cycle).
Close the dishwasher door. The dishwasher will
begin and run until the cycle is complete. When
the dishwasher door is closed, the INFOLIGHT™
will illuminate and cast a red circle on the floor to
indicate the dishwasher is running.
When the cycle ends, the dishwasher will emit an
end of cycle tone (five times). The display will
briefly show "Clean". After 5 seconds the
dishwasher and the INFOLIGHT™ will
automatically turn off.
NOTE: To accelerate and enhance drying, open
the dishwasher door, pull the top rack a few
inches out of the dishwasher, and prop the
dishwasher door against the top rack.
Interrupting a cycle
SCALD HAZARD: You could be seriously
scalded if you open the dishwasher door
quickly during a wash or rinse cycle. Do
not fully open the dishwasher door for at
least 10 seconds or until water noises
stop.
Open the dishwasher door far enough to expose
the control panel. The display will show:
• "Cancel Program".
• "Close the door".
• the remaining cycle time.
• the selected cycle.
• the cycle phase.
To continue the cycle, shut the dishwasher door.
The dishwasher will start automatically and
continue the selected cycle.
WARNING